the electric vibrators

1, the electric vibrators (1), the plug-in vibrator motor supply, install leakage protection device, ground or zero should be safe and reliable. (2), the operator should go through electricity education, should work shoes worn insulation and insulated gloves. (3), the cable operator should meet the required length, concrete vibrator for sale china the cable lines can not heap pressure items or allow the vehicle to squeeze, drag or non-electric cables hanging vibrator. (4), before use, you should check and confirm the ministries connected securely, the rotational direction is correct. (5), a vibrator can not be tested in the initial setting of concrete vibrator, floor, scaffolding and hard, dry ground. Interrupted during maintenance operations, disconnect the power supply. (6), the job, the bending radius vibrator hose not less than 500mm, and not more than two bends, the operation should be vertical rods deep into the concrete, Do not slam the hard insert, bench presses or let reinforced sandwich bar head, nor fully inserted into the concrete, the insertion depth should not exceed 3/4 of rod length should not touch the steel, the core tube and embedded parts. (7), may not appear vibrator hose break, when the hose length is increased when used for a long time to make, should be repaired or replaced. (8), the job is stopped when the need to move the vibrator, you should shut down the motor, and then cut off the power supply. Not use a hose drag motor. (9), the job is completed, should be the motor, hoses, vibrator clean, and should be required to carry out maintenance work requirements. When the vibrator is stored can not heap pressure hose should be straight away, concrete vibrator flexible shaft for sale and moisture-proof measures taken to deal with the motor. 2, the electric attachment, electric flat vibrator (1), attachment type, flat vibrator bearings should not be subjected to axial force, when used, the motor shaft should be kept horizontal. (2) on a template simultaneously using multiple attached vibrator, the frequency of each vibrator should be consistent, the opposing surface of the vibrator should be staggered installation. (3), before the job is to deal with vibrator attachment for inspection and vibration test, vibration test shall be carried out in dry hard soil or on a hard object. Vibrator mounted on the silo mixing station, should resettlement rubber pad. (4), when installed, the vibrator plate mounting holes should be positioned correctly, prevent foot bolt mounting skew leaving the cabinet has been damaged. Foot bolts should be tightened, the tightness of the bolts should be consistent. (5), when in use, leads to cable must not pull tight, but can not break. When the job, you should always observe the earth leakage protection and electrical equipment or device connected to zero and confirm eligibility. (6), when attached to the vibrator is mounted on a concrete form, each vibration time should not exceed 1min, when the concrete slurry flow in the mold or pan horizontally like you can stop vibration, the vibration can not be real again in the initial setting of concrete state ʱ?? (7), the template device vibrator member concrete vibrator china brand firm should be strong, the area should be adapted to the vibrator rated vibration area. (8), when the plate vibrator operation, the plate should remain in contact with the concrete, so effectively tap Discovering concrete, until the surface of the paddle, not after the sinking, you can slowly moving forward, moving speed should be able to ensure the concrete tap the paddle. In the vibration of the vibrator, can not rest on the condensate or the initial setting of concrete have been.