Rebar cutter Jiaodi content

Rebar cutter Jiaodi content 1. Check before using the blade installed correctly. Fixed blade knife and activities between the horizontal gap to 0.5 ~ 1mm appropriate. 2. It must be confirmed before being put into use after a normal load test run. 3. When cutting, must be reinforced grip, the knife should be at the event to 350l hot sale jzr350 diesel engine concrete mixer the time back, the steel into the blade to prevent steel end swing or pop into injury. 4. When chopped steel, must clamp feed with pliers. Iron, iron and other dirt can not be the end of the hand wiping. 5. Steel, red-hot steel and more than the blade material hardness within the non-cutting limits. 6. Machinery is operating normally, are allowed to feed off. When cutting, hand and edge distance not less than 15cm. When the movable blade forward feed ban. 7. Cutting steel not exceed the mechanical load capacity, cut low-alloy steel and other special steel bars high hardness blade. 8. Cut long steel should be someone to hold on, the operation action should be consistent, not arbitrarily drag. Chopped reinforcement shall cannula Or pliers material may not be direct hand feeding. 9. Cutting machine should be located next to put the production units, mechanical operation, do not touch directly remove short head and debris near the edge. 10. Then pound countertop material should maintain the level of the lower part of the puzzle, the length of the table can be determined according to the length of the workpiece. 11. Before you start, you must check the knife should not crack, Turret bolt, solid shield. Then turned by hand Pulleys, check the gear meshing clearance, adjust the cutter gap. 12. When cutting short material, distance between the hand and the knife should be kept more than 150mm, such as when hand side is less than 400mm, use a sleeve or short jig head pressed steel or folder in prison. 13. Mechanical operation found no abnormal noise or skew cutter, etc. properly, hot sale price of mobile concrete mixer jzm500you should immediately stalled engine overhaul. 14. After the operation, steel brush to remove debris between the cutter, carry out the whole cleaning and maintenance. Rebar cutter safety rules 1, then, feeding the working platform and the bottom blade should be level. 2. Before use, the operator should check the blade for cracks, turret bolts are tightened, the shield is solid, and then carried by hand pulley, gear check and adjust the blade clearance. 3, after the start, the first no-load operation, check all parts of the transmission and bearing is functioning properly. 4, when the machinery is not up to speed, not allowed to be cutting, you must use the lower shear blade when cutting. 5, can not be cut more than equipment specified diameter and bar diameter or red-hot steel, a plurality of cutting steel, the total cross-sectional area less than the required safety technology requirements. 6, steel cutting must be carried out straight after the operation, when the broken material to grip steel, steel and so maintain the vertical blade and the movable blade to the back when the steel into the blade, to prevent the end of the swing bars or pop wounding ,have an accident. 7, when the cutting machine chopped material from near the blade or blade hand must be maintained at between 15cm or more, such as when hand side less than 40cm, use a jig or tube, the reinforcement end pressure prison, prohibited by hand directly feed for cutting operation. 8, cutting machine in operation, prohibited by hand directly decapitation or remove stationary 120m3 h concrete batching plant debris on the blade. 9, found that the mechanical operation is not normal or abnormal skew blade should immediately downtime, etc., are not allowed to use sick of mechanical operation. 10, after the job is completed, you should cut off the power, and other machinery after a complete stop to steel brush to remove debris between the cutter ring maintenance, repair