Mixing station ingredients work request

Mixing station ingredients work request  Concrete mix station stop mixing concrete in the process, the ingredients work is a vital part, it works directly with resolution quality construction projects, it is necessary cause focus. In detail, the following request: 1, pay attention to the ingredients mixing station demarcation unit. Different machines have different ingredients calibration factor, so that the same dosing machines, different specifications of the aggregate, concrete mixer truck for africa different material door opening degree also has a different calibration factor. Accordingly, when we change the specifications and adjustment aggregate feed door opening, it is necessary to recalibrate corresponding to the batching machine calibration coefficients. Especially before use, but should focus on calibration work batching machine. 2, to ensure mixing station batching units in aggregate specification differences. This is important, because if the aggregate size is not divided, it will affect the mix gradation shaken, but also seriously affect the performance of the mix. Thus enhancing stockpile management should strictly avoid seizure mix; while also carefully hand loader operations, to avoid the onset of mixing positions. 3, before starting the mix station, press the "Power Min divisions" button to show alarm rang a few times until the outdoor power and ensure that there will be no re-boot problem, in addition, we can be warned through loudspeakers , should an emergency situation, we can pass this way to be warned. 4, the device out of the stabilized soil mixing mixture ratio and moisture content, we can use the sampling profiling method to stop affirmative, then on the basis of analysis results, again for each batching machine and adjust the water flow is stopped and accurate. 5, stirring standing formal work, concrete mixer truck dasion 10cbm to equip three skilled workers, one of whom served as the operation of the entire device operation in the console, the other two stop equipment operation status, rationing of materials and material conditions for inspections and stop monitoring, adjustment. Once the problem was found, promptly notify the operator of harmonic treatment or stop down for disposal. The principle of concrete mixing station selection Concrete mixing station destination device request Concrete mixing equipment in the process of standing in the center of attention of some of the requirements, otherwise, it may attack risk in the use of the process. We are all summed up eight Request: 1, in the apparatus during non-compartment body showing inclined legs deformation phenomena. 2, to ensure that the bottom of the leg with embedded welding solid foundation. 3, must be good wind, lightning work. 4, stop strong impact legs and body positions. 5, to regularly check the condition attached dust bag of cement, and make liquidation. 6, mixing station essential foundation strong, fit the architectural design standards. 7, once blocked the bag, the pressure inside the warehouse beyond the warehouse roof pressure safety pressure safety valve, pressure safety valve to open positions within the release pressure and to avoid the hdt5313gjb concrete mixer truck onset of warehouse explosion incident. 8, when the cement silo work required by a special crane to be erected, then placed on top of a good pre precast concrete foundation and erected cement silo after checking the degree and extent of vertical surface, and then the bottom of the foundation embedded welding firm.