Steel bending machine when using what needs attention

Steel bending machine when using what needs attention 1, the stopper shaft diameter and strength may not be less than the diameter of bent steel and strength. Not straight bars, can not bend in the bending machine.  2, when the job will need to bend one end of the steel insert in the gap turntable fixed pin, fixed pin the other end against the body, and hand pressed, check the body on one side of the pin block safety indeed reinforced before starting . bend art bend machine for stainless steel aluminum Longer bars during processing, should be someone helping, and obey the command of the operator, shall be arbitrarily sliding.  3, in the bending radius of the fuselage reinforced job no fixed pin side strictly prohibited. Curved good semi-finished products should be stacked neatly, hooks shall not be upward.  4, according to the requirements of processing rebar diameter and bending radius, installed the appropriate size and shape of the mandrel shaft, gear shaft or variable iron fences, mandrel diameter should be 2.5 times the bar diameter, due axle shaft stopper set.  5, when bent without cold-drawn or reinforced with rust skin should wear protective glasses.  Matters steel bending machine should be paid are:   1. Check the mandrel, the stopper, the turntable should be no damage and cracks, securing reliable shield, after confirming normal operation by air, before the job.   2, when the job will need to bend one end of the bars inserted in concrete needle vibrator for sale price the space-bending machine turntable fixed pin, fixed pin the other end against the body, and hand pressed, check the body indeed safe side of the retention pin block reinforcement before starting.  3, bending steel, shall not exceed the machine specified rebar diameter, root number and mechanical speed.  4, according to the requirements of processing rebar diameter and bending radius of the installed spindle molding axis, iron shaft gear or a variable fences, mandrel diameter should be 2.5 times the bar diameter.  5, reinforced to snapping the shutter, note the location and direction of rotation into the plug must not open the wrong. Steel cutting machine safety instructions 1, preflight check leakage protection, the blade is solid supply wiring is correct, the various electrical components insulation is intact, if there are transmission parts guard, whether the body has reliable access to zero (ground) protection. Confirm before use no problem. 2, the use must be empty before commissioning, confirming that no abnormalities before they can officially start work. 3, in the steel cutting, must be reinforced pushed tight until after the events of the blade retracted into the steel cutting edge, prohibit or processing exceeding the specifications of excellent bars. Cut low-alloy steel and other special steel, high hardness blade applications. 4, cut short when the material must be clamped evacuation material with pliers to prevent the end of the swing wounding. 5, when cutting long materials, should two operations, concrete vibration table motor later listen to the previous command, cooperation and coordination, can not arbitrarily pull. 6, in the mechanical operation of the process is prohibited adjustment, maintenance and cleaning. 7, when replacing blades and repair, replacement power after the first. Processed reinforcement should be put neatly coded, reinforced head off, and must be clean. After machining wind up its power, before leaving the gate locked box.