How to use the steel bending machine

How to use the steel bending machine First, use the ready: Responding to conduct a comprehensive inspection of steel bending machine, and load test run. Second, the security check: body should be grounded, the power does not allow direct access to the button, you should install another switch box. Third, the operation process: 1, was tested on the interception of a long metal wire 200-250mm period, patented technology hzs25 concrete batch plants for sale straightening, straightening must not damage the wire surface. 2, according to the parameter list to select the clip wire diameter circle radius r, the lever clip to the underside of the top of the arc distance b, and lever hole Φ, clips on each pay a radius of curvature of digital prints to choose from the distance b is adjusted by the lever arm on the location of the three holes obtained, the following sequence 35,50,75 up lever hole Φ according to numbers around the hole lever print identification. 3, there are four holes perpendicular to each other on the main lever, align the lever in the direction you need to obtain holes, when using the threaded end of the hole should be put on the sleeve, use the other end of the hole should be Remove the sleeve to ensure that the wire is bent the center line. 4, the rocker arm in a vertical position, and thus as the starting state test, the sample first hole penetrated two tablets sandwiched floor, then vertically upward from the lower lever through the lever hole rethread the clip to the top, turn the handle on the cartridge to clamp the upper end of the wire. 5, hand to clamp down on the press after 15-25mm stabilize imer twin shaft stationary concrete mixer parts (coarse wire distance should have 15-25 kg of the wire tensioning force) Turn the handle to the lower end of the main clip clamping bending. 6, when bending specimens should be used more uniform speed (about 1 times / sec). 7, bend count is bent 90 ° to the right from the starting position, then return to the starting position the sample for the first time, then left bend 90 °, the sample and then the anti-back to the starting position for a second, so to break up the sample, the sample broken last bend insensitive. 8, circular surface after prolonged use clip appear if traces of crushing the clip should be replaced. 9, oil cups and relative sliding shall constantly refuel and maintain lubrication. 10, should wipe with a clean and coated with anti-rust oil to prevent corrosion. Fourth, Operation Note: (1) No replacement center axis in operation, forming iron shaft or gear shaft. Refueling is prohibited or wipe the machine during operation. (2) placing steel iron shaft gear to and work with the disk rotation direction, do not put reversed. (3) is not straight bars, prohibit bent on bending machine, to prevent accidents. (4) bending steel, shall not exceed the concrete mixer truck reduce gearbox machine specified rebar diameter, root number and mechanical speed. (5) prohibited within the operating radius of curved steel and the body does not have to stand on one side of the fixing pins. Good semi-finished products should be stacked neatly bent, curved configurations may not upward.